Fleischmann decoder (687401)
I installed the decoder in a new loco (Fleischmann) following the instuctions.
I noted that the loco works on DC mode (but not the lights) and on DCC mode does not work anything.
I have a MRC prodigy advance 2 system, and all the decoders I have programmed with out problem (esu, mrc, digitrax, etc.), I don´t know if to programme the decoder (Fleischmann) I have to do something different or is the same as the others decoders ?
I only programmed the address, but does not work.
Should I try to connect inverting the pins ?
I tink that the decoder is defective ???
Thanks
Comments
The 6-pin NEM-connector used by Fleischmann is not plug symmetric. Moreover, Fleischmann plugs are not marked in the same way as Roco where a little mark indicates the position of the orange wire. I would suggest turning the decoder 180 degrees.
Ulrich